Pipe Slope Calculator
Work out drainage pipe slope (total fall over a run, as inches, percent, and angle) and see the recommended slope for the pipe size. Calculates in your browser.
Total fall
-
Show the math
Fall is the run length times the slope per foot:
fall = run × slope per foot
slope% = (slope per foot ÷ 12) × 100
A common minimum is 1/4 inch per foot for pipes up to 2.5 inches and 1/8 inch per foot for 3 inches and larger. Too steep can let water outrun solids. All math runs locally in your browser.
What this does
A pipe slope calculator works out drainage slope (total fall over a run, as inches, percent, and angle) and shows the recommended slope for the pipe size.
How to use it
- Enter the run length.
- Enter the slope per foot.
- Or pick the pipe size for a recommendation.
- Read the fall, percent, and angle.
How it works
A common minimum is 1/4 inch per foot up to 2.5-inch pipe and 1/8 inch per foot for larger. Too steep can clog.
fall = run length × slope per foot
Understanding your result
The recommended slope is a balance: too little and waste water sits and stalls, too much and the liquid races ahead of the solids and leaves them behind to clog. Aim for a steady, consistent fall along the whole run rather than dips and humps, and treat the minimum as code-driven, since drainage rules are strict for good reason.
Example
A 20-ft run at 1/4 inch per foot drops 5 inches.
Sources & methodology
Last updated .
Frequently asked questions
What slope should a drain pipe have?
A common minimum is 1/4 inch per foot for pipes up to 2.5 inches and 1/8 inch per foot for 3 inches and larger. The tool suggests this by size.
Why not steeper is better?
Too steep can let water outrun solids and cause clogs; the standard slopes balance flow velocity and solid transport.
How is fall calculated?
Fall = run length × slope per foot. The tool also shows the slope as a percentage and an angle.
Is my data saved?
No. Everything is calculated locally in your browser.
Related tools
BTU Calculator
Estimate the cooling BTU and tons an air conditioner needs for a room from its size, ceiling height, sun exposure, occupants, and whether it’s a kitchen. Calculates in your browser.
HVAC Load Calculator
Get a rough whole-house heating and cooling load in BTU and tons from the floor area, climate-based factors, window count, and occupants. Calculates in your browser.
Drywall Calculator
Work out the drywall sheets a project needs from the wall and ceiling area and sheet size, plus screws, joint compound, and tape. Calculates in your browser.
Conduit Fill Calculator
Check NEC conduit fill (total conductor area versus the allowed percentage for EMT) from your wire gauges and counts, with a pass or fail. Calculates in your browser.